DacorRepair Miami

Service

Dacor built-in microwave repair

A built-in microwave is worth repairing where a countertop one is not: it is fitted, matched to the kitchen and expensive to replace, and the usual problems are ordinary. Doors and interlocks, control panels, turntable drives and cooling fans account for most calls. The one symptom we ask people to stop using the appliance for is a machine that runs, lights and turns while producing no heat — that is the high-voltage side, and it is a routine repair for somebody equipped for it and a genuinely dangerous one for anybody else.

  • From $95 diagnostic, credited to the repair
  • 59 cities and neighborhoods covered
  • OEM parts available on order
  • In writing the price, before anything is opened

Before you read on

What this job costs and how it is agreed

A starting figure, not a quote. What moves it is the model, how the unit is built in and which part it needs — settled after the on-site diagnostic.

Starts at

from $195

After a diagnostic from $95, which comes off the bill when you go ahead.

Diagnostic

From $95, credited to the repair

The price

In writing, before anything is opened

Warranty

On the labor we performed

On the visit

How this visit actually goes

The same order every time, so nothing is opened and nothing is charged before you have seen the figure and said yes.

  1. 01

    Establish whether it heats at all

    A measured load, timed. It separates the trivial problems from the one that matters.

  2. 02

    Check the door and its interlocks

    Three switches in sequence on most machines, and a door that has dropped will fail them in a particular order.

  3. 03

    Work the high-voltage side only if it is the answer

    Discharged, tested and replaced properly. This is the part of the appliance that earns the caution.

Applies to

  • A stainless microwave drawer built into a run of dark oak cabinetry below a stone worktop, the drawer slid fully open to show an empty cavity, seen from slightly above.
    Drawer, over-range convection and countertop

    Dacor microwave repair in Miami

    Three quite different appliances share the word here. The drawer microwave sits below the worktop and opens downward — about 1.2 cubic feet and 950 watts, with sensor cooking. The over-range unit is a combination machine: a convection microwave and a ventilation hood in one 30-inch body, which means a problem in it can present as a cooking problem or a venting one. And there is a countertop machine, the one appliance in this catalog that can simply be replaced rather than repaired. Which of the three is in the kitchen decides whether this is a joinery job, a hood job, or neither.

    • Drawer microwave: 1.2 cubic feet, 950 watts, sensor cooking, opens downward
    • Over-range unit combines convection microwave and hood in one 30-inch body
    • The countertop machine is genuinely replaceable — we will say so when it is
    Microwave repair

In more detail

About Dacor built-in microwave repair

Worth repairing, unlike its countertop cousin

A built-in or drawer microwave is fitted, matched to the kitchen and expensive to replace, and the usual problems are ordinary: doors and interlocks, control panels, turntable drives, cooling fans. The one symptom we ask people to stop using the appliance for is a machine that runs, lights and turns while producing no heat — that is the high-voltage side, and the capacitor in it holds a charge long after the plug is out. Routine for somebody equipped for it, genuinely dangerous otherwise.

This article is based on:

  • Official manufacturer documentation
  • Internal repair procedures
  • Technician repair history
  • Company quality standards

Before you book

Questions about Dacor built-in microwave repair

It runs but nothing gets hot.

Stop using it and do not open it. The problem is on the high-voltage side, and that is the one part of a kitchen appliance that can hurt somebody after it is unplugged.

Is a countertop machine worth fixing?

Usually not, out of warranty, and we will say so. That costs us the visit and it is the reason the advice on the built-in machines can be trusted.

Tell us the model number and what it is doing.

Call (305) 363-6067